Heavy Duty Vertical Bonding

Features and Specifications:

With Power Grab n Bond there is absolutely no need for any additional fixings as it was initially developed for facade bonding. In addition Power Grab n Bond has a capacity to adhere to endless materials such as stone, granite, marble, concrete, all metals (including alloys), polystyrene and most plastics.

Power Grab n Bond’s ability to bond combined materials such as wood to concrete or stainless steel to stone is incredible. As already outlined Power Grab n Bond was initially developed for façade applications, conventional methods relied on two component epoxy mix to adhere the marble or granite slab to the block wall. Depending on the weight of the slab each one would then have to be supported by drilling in ties to support each one. As with all epoxies they can be temperamental if the correct mix is not achieved. Also full cure can be between 24 and 72 hours.

Power Grab and Bond has none of these disadvantages.

Technical Data:

• Density - 1569kg/m³
• Curing in 24hrs - 2-3mm
• Shrinkage - None
• Skinning Time - 10-15mins
• E-Modulus 100% - 1.39 Mpa
• Volume shrinkage after cure - none
• Hardness – DIN 53505 Shore A  - 60°
• Tensile strength  - 22Kg / cm²
• Thermal stability - -40ºC till + 100ºC
• Elongation at rupture (DIN 53504) - 335.00%

Chemical resistance:
Good:
Water, seawater, aliphatic solvents, oils, greases, Diluted organic acids.

Moderate:
Esters, ketones, Aromatics

Bad:
Concentrated acids, chlorinated solvents, High concentrations of chlorine